Transparency Specifications
Overhead transparencies used in HP LaserJet printers must be
able to withstand the 392° F (200° C) temperatures encountered in
the printer’s fusing process for 0.1 second. Suitable transparency
film is available through Hewlett-Packard. Refer to Chapter 3 of
the HP LaserJet Printer Family Paper Specification Guide, HP
Part No. 5002-1801 for details.
Caliper 13.9 to 4.3 roils (0.100 to 0.110 mm)
Cutting Angle
90° * 0.2°
Finishing precision Cut sheet to within 0.03 in. (0.8 mm) of nominal
and t 0.2° of square.
Fusing Compatibility Overhead transparency material must be
compatible with the heat and pressure of the fusing
process. Materials must not discolor, melt, offset
material, or release hazardous emissions when
heated to 392° F (200° C) for 0,1 second.
The “flat paper pat~ (manual feed slot and rear
face-up delivery door) is recommended for
printing transparencies.
2-15
To Next Page
Loading...