Installation and Configuration
Llnpacking and Installation
E. Load the paper cassette.
1. Pull out the paper cassette located at the lower front of printer
and load approximately 100 sheets (4L/4ML) or 250 sheets
(4P/4MP) of paper. The rear of the stack should fit loosely under
the two backstops at the rear of the paper cassette.
2. Insert the front corner of the paper stack under the metal clip
at the front of the cassette.
Note
Failure to insert the paper under the metal clip
will cause skewing or paper jams.
3. Resting the paper cassette on a flat surface, slide it into the
printer.
F. Attach the interface cable(s).
1. Open the 1/0 Door on the printer’s left rear side (LaserJet
4L/4ML only). Attach the 1/0 cable securely to the printer.
Note
Failure to attach the cable securely may result
2.
3.
in an 1/0 error.
LaserJet 41J4ML: Align the cable with
the 1/0 Door.
Attach the I/O cable to the computer.
the cable hole and close
3-4
To Next Page
Loading...