HP LaserJet 5 - Load Paper into Tray 1

Step 7. Load Paper into Tray 1
Tray 1 allows you to automatically feed up
to 100 sheets of paper or manually feed one
sheet at a time. Tray 1 can be used for
standard and odd-sized papers, envelopes,
labels, and transparencies.
To load Tray 1:
1 Open Tray 1 by pulling down on the
top center of the door.
2 Pull out the tray extension until it
clicks into place.
3 Slide the paper width guide to the far
right side of the tray.
4 Place paper in the tray. The paper
should be flush left, under the arrows
on the paper guide tabs.
Note
See the sections on letterhead, envelope,
and duplex printing in Chapter 4 of the
User’s Manual for proper media
orientation for specific jobs.
5 If necessary, slide the paper width
guide to the left until it lightly
touches the stack of paper without
bending the paper.
EN Getting Started Guide 11