Registration unit
1. Remove the following components:
●
Right cover. See
Right cover on page 86.
●
Lower back cover or duplexer. See
Lower back cover on page 86 or Duplexer on page 84.
●
Face-up bin. See
Face-up bin on page 87.
2. Open the print-cartridge door.
3. Unhook one claw (callout 1), and remove the guide (callout 2) and the gear cover (callout 3).
Hint Pop the guide and the gear cover from the top, and slide them toward you.
Figure 5-120 Removing the registration unit (1 of 2)
4. Remove two screws (callout 4).
134 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...