2. Using a flatblade screwdriver, lift up the transfer roller (callout 1) on the left side of the printer and
slide it to the left to remove it.
Figure 5-122 Removing the transfer roller
NOTE Do not touch the rubber sponge on the transfer roller.
NOTE When you reinstall it, install the transfer roller on the right side of the printer and then
snap it into the left side of the printer.
Paper-feed unit
1. Remove the following components:
●
Right cover. See
Right cover on page 86.
●
Lower back cover or duplexer. See
Lower back cover on page 86 or Duplexer on page 84.
●
Face-up bin.
Face-up bin on page 87.
●
Top cover. See
Top cover on page 89.
●
Fuser. See
Fuser on page 112.
●
Transfer roller. See
Transfer roller on page 135.
136 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...