4. Unhook one spring (callout 3) from the metal hook.
Figure 5-197 Removing the 500-sheet feeder lifter drive unit (2 of 3)
5. Remove one screw (callout 4) and one holder (callout 5).
6. Remove the 500-sheet feeder lifter drive unit (callout 6).
Figure 5-198 Removing the 500-sheet feeder lifter drive unit (3 of 3)
NOTE When you reinstall the unit, a lift motor error message (59.XX) appears on the control-
panel display if you do not reinstall the unit correctly.
ENWW 500-sheet feeder 181
To Next Page
Loading...