HP LaserJet 5200

5. Press or to select the desired option, and then press .
6. Press Menu to exit the menu.
Tray-behavior options
Four user-defined options are available for tray behavior:
●
USE REQUESTED TRAY. Selecting EXCLUSIVELYensures that the printer does not
automatically select another tray when you indicate that a specific tray should be used.
Selecting FIRST allows the printer to pull from a second tray if the specified tray is empty.
EXCLUSIVELY is the default setting.
●
MANUALLY FEED PROMPT. If you select ALWAYS (the default value), the system always shows
a prompt before pulling from the multipurpose tray. If you select UNLESS LOADED, the system
displays the prompt only if the multipurpose tray is empty.
●
PS DEFER MEDIA. This setting affects how non-HP PostScript drivers behave with the printer.
You do not need to change this setting if you use the drivers that HP supplies. If set to
ENABLED, non-HP PostScript drivers use the same HP tray selection method as the HP drivers.
If set to DISABLED, some non-HP PostScript drivers use the PostScript tray selection method
instead of the HP method.
●
SIZE/TYPE PROMPT. Use this item to control whether the tray configuration message and its
corresponding prompts are shown whenever a tray is opened and closed. These prompts instruct
you to change the type or size if the tray is configured for a different type or size than is loaded in
the tray.
To set Use Requested Tray
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight SYSTEM SETUP, and then press .
4. Press
to highlight TRAY BEHAVIOR, and then press .
5. Press to select USE REQUESTED TRAY.
6. Press
or to select EXCLUSIVELY or FIRST, and then press .
7. Press Menu to exit the menu.
To set Manually Feed Prompt
1. Press Menu.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight SYSTEM SETUP, and then press .
4. Press
to highlight TRAY BEHAVIOR, and then press .
5. Press
to highlight MANUALLY FEED PROMPT, and then press .
6. Press
or to select ALWAYS or UNLESS LOADED, and then press .
7. Press Menu to exit the menu.
254 Chapter 6 Troubleshooting ENWW