Configure Device menu
This menu contains administrative functions. The CONFIGURE DEVICE menu allows the user to
change the default printing settings, adjust the print quality, and change the system configuration and
I/O options.
Printing submenu
Some items on this menu are available in the program or printer driver (if the appropriate driver is
installed). Program and printer-driver settings override control-panel settings. In general, it is better to
change these settings in the printer driver, if applicable.
Item Values Explanation
COPIES 1 to 32000 Sets the default number of copies by selecting any number from
1 to 32,000. Use
or to select the number of copies. This
setting applies only to print jobs that do not have the number of
copies specified in the program or printer driver, such as a UNIX
or Linux program.
The default setting is 1.
NOTE It is best to set the number of copies in the
program or printer driver. (Program and printer-driver
settings override control-panel settings.)
DEFAULT PAPER SIZE Displays a list of available
media sizes.
Sets the default image size for paper and envelopes. This setting
applies to the print jobs that do not have a paper size specified in
the program or printer driver. The default setting is LETTER.
DEFAULT CUSTOM PAPER
SIZE
UNIT OF MEASURE
X DIMENSION
Y DIMENSION
Sets the default custom paper size for tray 1. This menu appears
only if the media-size switch in the selected tray is set to
CUSTOM.
UNIT OF MEASURE: Use this option to select the unit of measure
(INCHES or MILLIMETERS) to use when you set customer paper
sizes for the tray 1.
X DIMENSION: Use this item to set the measurement of the width
of the paper (measurement from side to side in the tray). The
options are 3.0 to 12.28 INCHES or 76 to 312 MM.
Y DIMENSION: Use this item to set the measurement of the length
of the paper (measurement from front to back in the tray). The
options are 5.0 to 18.50 INCHES or 127 to 470 MM.
DUPLEX OFF
ON
Appears only for printers that include a built-in duplexer. Set the
value to ON to print on both sides (duplex) or OFF to print on one
side of a sheet of paper.
The default setting is OFF.
DUPLEX BINDING LONG EDGE
SHORT EDGE
Changes the binding edge for duplex printing. The menu item
appears only if the printer includes a built-in duplexer and
DUPLEX=ON.
The default setting is LONG EDGE.
OVERRIDE A4/LETTER NO
YES
Allows the printer to print an A4-size job on letter-size paper if A4-
size paper is not loaded in the printer (or vice versa).
The default setting is YES.
266 Chapter 6 Troubleshooting ENWW
To Next Page
Loading...