HP LaserJet 5200 - Page 311

Diagnostics
Two LEDs on the formatter indicate that the printer is functioning correctly.
Figure 6-27 Formatter lights
1 Heartbeat LED
2 HP Jetdirect LEDs (only available on the N, TN, and DTN bundles)
NOTE An EIO slot is not available for the HP LaserJet 5200L.
Embedded HP Jetdirect LEDs
NOTE Embedded HP Jetdirect LEDs are not available for the 5200 or 5200L models.
The embedded HP Jetdirect print server has two LEDs. The yellow LED indicates network activity, and
the green LED indicates the link status. A blinking yellow LED indicates network traffic. If the green LED
is off, a link has failed.
For link failures, check all of the network cable connections. In addition, you can try to manually configure
the link settings on the embedded print server by using the printer control panel menus.
1. Press Menu to enter the menus.
2. Press
to highlight CONFIGURE DEVICE, and then press .
3. Press
to highlight I/O, and then press .
4. Press
to highlight EMBEDDED JETDIRECT MENU, and then press .
5. Press
to highlight LINK SPEED, and then press .
6. Select the appropriate link speed.
ENWW Diagnostics 291