10. Reconnect the interface cable(s) and the power cord.
11. Turn the printer on.
Checking DIMM installation
After installing the DIMM, make sure that the installation was successful.
To verify that DIMMs are installed correctly
1. Turn the printer on. Check that the Ready light is illuminated after the printer has gone through the
startup sequence. If an error message appears, a DIMM might have been incorrectly installed.
2. Print a configuration page (see
Configuration pages on page 283).
3. Check the memory section on the configuration page and compare it to the configuration page that
was printed before the memory installation. If the amount of memory has not increased, the DIMM
might not be installed correctly, or the DIMM might be defective. Repeat the installation procedure.
If necessary, install a different DIMM.
NOTE If you installed a printer language (personality), check the "Installed Personalities and
Options" section on the configuration page. This area should list the new printer language.
34 Chapter 2 Installation and configuration ENWW
To Next Page
Loading...