Before performing service
WARNING! Turn the printer off, wait 5 seconds, and then remove the power cord before
attempting to service the printer. If this warning is not followed, severe injury and damage to the
device can result.The power must be on for certain functional checks during troubleshooting.
However, the power supply should be disconnected during parts removal.
1. Remove all media.
2. Place the product on an ESD mat (if available).
3. Remove the print cartridge.
4. Remove tray 2.
After performing service
●
Return all media to the trays.
●
Plug in the power cable and turn on the printer.
●
Reinstall the print cartridge.
●
Reinstall tray 2.
Parts removal order
Use the following diagram to determine which parts must be removed before removing other parts.
68 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...