ENWW Loading input trays 37
3 Adjust the paper guides so that they lightly touch the paper stack, but do not bend the paper.
4 Make sure that the paper fits under the tabs on the guides and that the stack does not extend
above the load-level indicators.
Note If printing on A3, 11 x 17, or other long media, also pull out the tray extension until it stops.
5 Look at the control-panel display within a few seconds of loading the paper. (Reload the
paper if the time has already elapsed.)
• If TRAY X <TYPE> <SIZE> does not appear on the control-panel display, then the tray is
ready for use.
• If TRAY X <TYPE> <SIZE> appears on the control-panel, press to change the size and
type configuration. The Size menu appears.
6 Press to highlight ANY SIZE.
7 Press to select ANY SIZE. The message SETTING SAVED appears on the control-panel
display
8 When the Type menu appears, press to highlight ANY TYPE.
9 Press to select ANY TYPE. The message SETTING SAVED appears on the control-panel
display.
10 If TRAY 1 ANY SIZE ANY TYPE appears on the control-panel display, then the printer is ready
for intermittent use of a variety of paper sizes and types. Press to accept the size and
type setting.
To load optional Tray 1 when the same paper is used for multiple
print jobs
Use the following procedure if Tray 1 is usually loaded with the same type of paper, and the
paper is not usually removed from Tray 1 between print jobs. The following procedure can usually
increase the printer performance when printing from Tray 1.
CAUTION To avoid a jam, never add or remove paper from a tray while printing from that tray.
1 On the control panel, press to open the menus.
2 Use or to scroll to PAPER HANDLING and then press .
3 Use or to scroll to TRAY 1 SIZE and then press .
4 Use or to scroll to the correct size and then press . The message SETTING SAVED
appears on the control-panel display.
Note If you select CUSTOM as the paper size, also select the unit of measure (the X and Y dimensions).
To Next Page
Loading...