Unsupported supply installed To continue, touch “OK”
Description
One or more genuine HP supplies designed for a different product are installed. These supplies are not
supported by the product. The product may either shut down or slow down.
Recommended action
The installed supply was not designed for this product and is not supported. Results may vary when
used with this product. To continue printing with the unsupported supply touch the OK button.
Unsupported USB accessory detected Remove USB accessory
Description
A non-supported USB accessory has been installed.
Recommended action
Turn the product off, remove the USB accessory, and then turn the product on.
Upgrade complete To continue turn off then on
Description
The firmware upgrade is complete.
Recommended action
Turn the product off and then on.
USB accessory needs too much power Remove USB and turn off then on
Description
A USB accessory is drawing too much electrical current. Printing cannot continue.
Recommended action
Remove the USB accessory, and then turn the product off and then on.
Use a USB accessory that uses less power or that contains its own power supply.
USB accessory not functional
Description
A USB accessory is not working correctly.
Recommended action
1. Turn the product off.
2. Remove the USB accessory.
3. Insert a replacement USB accessory.
ENWW
Tools for troubleshooting
323
To Next Page
Loading...