Table 2-49 MP modes under the Optimize submenu (continued)
Transfer Control Set to Alternate 1 to reduce primary transfer bias and to
resolve low density or blotchy images. Set to Alternate 2 to
resolve ghosting outlines that look like a finger or fingers. Set
to Alternate 3 when the other alternatives do not correct the
problem.
Fuser Temp The default setrting for this item is Normal. Use the Alternate
setting to reduce the occurance of first-page fuser wrinkle or
toner blister.
Restore Optimize Use this item to reset the menu defaults.
ENWW
Use manual print modes
363
To Next Page
Loading...