Table 2-48 Print modes under the Adjust Paper Types sub menu (continued)
Fuser Temp Mode If you are seeing a faint image of the page repeated at the
bottom of the page or on the following page, first make sure
the paper type (Adjust Paper Types menu) and Print Mode
settings are correct for the type of paper you are using. If you
continue to see ghost images on your print jobs, set the Fuser
Temp feature to one of the settings.
Normal
Up
Down
Paper Curl Mode Use in high-humidity and high-temperature environments. The
Reduced setting decreases fuser temperature and increases
the interpage gap.
Table 2-49 MP modes under the Optimize submenu
Normal Paper Set to Smooth when printing on smooth paper of normal
weight.
Heavy Paper Set to Smooth when printing on smooth, heavy paper types.
Envelop Control Use this mode if envelopes are sticking together due to
moisture in the envelope adhisive.
Normal
Reduced Temp
Environment Set to Low Temp if the product is operating in a low-
temperature environment and you are having problems with
print quality such as blisters in the printed image.
Line Voltage Set to Low Voltage if the product is operating in a low-voltage
environment and you are having problems with print quality
such as blisters in the printed image.
Tray 1 Set to Alternate if you are seeing marks on the back side of
the paper when printing from Tray 1. This sets the product to
initiate a clean sequence every time a job finishes when the
product is set for Any Size and Any Type for Tray 1.
Background Set to Alternate 1 when a background occurs all over the
page. Set to Alternate 2 when thin vertical lines appear on the
page. Set to Alternate 3 when the other alternatives do not
correct the problem.
Uniformity Control Set to Alternate 1 to improve uniformity on any paper type.
Set to Alternate 2 to improve uniformity on normal and light
paper types. Set to Alternate 3 when the other alternatives do
not correct the problem.
Tracking Control The default setting is On. This item is for manufacturing use
only.
Registration Set to Alternate when color misregistration occurs.
362 Chapter 2 Solve problems ENWW
To Next Page
Loading...