Recommended action
Use the HP Embedded Web Server or HP Web Jetadmin to initialize the file system.
Size mismatch in Tray <X>
Description
The paper in the listed tray does not match the size specified for that tray.
Recommended action
1. Load the correct paper.
2. Verify that the paper is positioned correctly.
3. Close the tray and verify that the control panel lists the correct paper size and type. Reconfigure
the size and type if necessary.
4. If necessary, use the control-panel menus to reconfigure the size and type settings for the specified
tray.
5. Make sure that connectors J513, J507, and J501 are fully seated on the high-voltage power
supply.
6. Make sure that connector J601 is fully seated on the DC controller PCA.
7. If the error persists, replace the high-voltage power supply.
8. If the error persists, replace the DC controller PCA.
Standard bin full Remove all paper from bin
Description
The specified output bin is full and must be emptied for printing to continue.
Recommended action
Empty the specified output bin.
Staple Cartridge low
Description
The product indicates when a supply level is low.
Recommended action
Replace the staple cartridge.
Staple Cartridge very low To continue, touch “OK”
Description
The product indicates when a supply level is very low.
244 Chapter 2 Solve problems ENWW
To Next Page
Loading...
