Image-formation system
Electrophotographic process
The electrophotographic process forms an image on the paper. Following are the major components
used in the process:
●
Toner cartridge
●
Transfer roller
●
Fuser
●
Laser/scanner
The DC controller uses the laser/scanner and HVPS to form the toner image on the photosensitive drum.
The image is transferred to the paper and then fused.
Figure 1-16 Electrophotographic process block diagram
Laser scanner
Cartridge
Transfer roller
High-voltage power supply
DC controller
Fuser
Laser beam
Engine controller unit
28 Chapter 1 Theory of operation ENWW
To Next Page
Loading...
