Manual sensor test
Performs tests to determine whether the paper-path sensors are operating correctly.
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Troubleshooting
●
Diagnostic Tests
●
Manual Sensor Test
Table 2-10 Manual sensor tests
Sensor or switch
name
Sensor
number
Replacement part
number
Description Paper-path sensor
test name
Testing of sensor
Cartridge-door switch SW501 RM1-8499-000CN Interlock switch SW501 Cartridge
Door
Open the cartridge
door.
Face-up detect sensor PS8001 WG8-5935-000CN Photointerrupter PS8001 Rear Door Open the rear door to
about 90 degrees.
Paper feeder media-
feed sensor - Tray 3
1
PS8008 CE530-69001 Tray 3 feeder unit PS8008 Tray 3 Feed
sensor
Remove the Tray 2
cassette, use a small
screwdriver to activate
the sensor through the
small slot toward the
front of the product.
Top sensor PS215 RM1-8617-000CN Top sensor PCA PS215 Top Open the cartridge
door, remove the toner
cartridge, raise the
registration shutter,
and then use a
screwdriver to activate
the sensor.
Paper width sensor PS225 RM1-8618-000CN Paper-width sensor
PCA
PS225 Paper Width 1 Open the cartridge
door, remove the toner
cartridge, and then lift
the registration flap to
activate the sensor.
Fuser delivery sensor PS2 RM1-8505-000CN Fuser (universal) PS2 Fuser Output Open the rear door,
and then use a
screwdriver to activate
the sensor.
Duplex media-feed
sensor
PS502 RM1-8519-000CN HVPS PS502 Duplexer
Refeed
Remove the Tray 2
cassette, push the
green button to drop
the duplex tray, and
then raise the tray.
ENWW
Tools for troubleshooting
73
To Next Page
Loading...
