3. Lift up on the low-voltage power supply, slide it forward, and then slightly pull it out of the product.
CAUTION: The power supply is still connected by several wire harnesses to the product. Do not
attempt to completely remove the power supply.
Figure 1-258 Remove the LVPS (3 of 6)
1
3
2
4. Disconnect one connector (callout 1), and then release the wire harness from the retainer
(callout 2).
Figure 1-259 Remove the LVPS (4 of 6)
2
1
188 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...