HP LASERJET ENTERPRISE 700 COLOR MFP M775dn - Page 220

Duplex drive assembly
Before proceeding, remove the following assemblies:
●
Formatter PCA. See
Formatter PCA on page 10.
●
Control-panel assembly. See
Control-panel assembly on page 5.
●
Intermediate transfer belt. See
Intermediate transfer belt on page 7.
●
Fuser. See
Fuser on page 9.
●
Left cover. See
Left cover on page 55.
●
Rear cover. See
Rear cover on page 56.
●
Right rear cover. See
Right rear cover on page 57.
●
Right upper cover. See
Right upper cover on page 65
●
Toner collection unit (TCU) access door. See
Toner collection unit (TCU) access door on page 58
●
Optional: Document feeder. See
Document feeder on page 69.
NOTE: HP recommends removing the document feeder to decrease the weight of the scanner
assembly when it is lifted off of the product.
●
Scanner assembly. See
Scanner assembly on page 72.
●
Front upper cover. See
Front upper cover on page 81.
●
Front right cover. See
Front right cover on page 84.
●
For a non stapler/stacker model:
◦
Output cover. See
Output cover; non stapler/stacker model on page 91.
●
For a stapler/stacker model:
◦
Stapler/stacker assembly. See
Stapler/stacker assembly on page 76.
●
Left upper cover. See
Left upper cover on page 80.
●
To right cover. See
Top right cover on page 89.
●
Top cover. See
Top cover on page 93.
●
Top rear cover. See
Top rear cover on page 95.
●
Sub power assembly. See
Sub power supply assembly on page 108
●
Paper delivery assembly. See
Paper delivery assembly on page 129.
●
Toner cover. See the first, second, and third steps of
Residual toner full sensor on page 120
●
Formatter cage assembly. See
Formatter cage assembly on page 177.
190 Chapter 1 Removal and replacement ENWW
DRAFT