HP LaserJet M1005 MFP - Scanning by using HP LaserJet Scan (Windows); Canceling a scan job

Scanning by using HP LaserJet Scan (Windows)
For more information about tasks and settings described in this section, see the HP LaserJet Scan online
Help.
For more detailed instructions about loading original documents onto the flatbed scanner, see
Loading
documents to copy or scan on page 24.
1. Click Start, click All Programs, click HP, and then click HP LaserJet M1005 MFP.
2. Select Scan To to start HP LaserJet Scan.
3. Select a scanning destination.
4. Click Scan.
Canceling a scan job
To cancel a scan job, use one of the following procedures.
●
On the device control panel, press Cancel.
●
Click the Cancel button in the onscreen dialog box.
If you cancel a scan job, remove the original from the flatbed scanner.
NOTE: These procedures vary with Macintosh operating systems.
ENWW Scanning by using HP LaserJet Scan (Windows) 57