Print-cartridge door
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
2. Open the print-cartridge door, and use a flatblade screwdriver to gently pry the cartridge-door arm
(callout 1) off of the print-cartridge door.
CAUTION: Be careful not to break the tabs on the cartridge-door arm.
Figure 5-12 Remove the print-cartridge door (1 of 3)
1
3. Close the print-cartridge door and remove two screws (callout 2).
Figure 5-13 Remove the print-cartridge door (2 of 3)
2
104 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...