Rear cover
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
2. Remove four screws (callout 1).
Figure 5-15 Remove the rear cover (1 of 3)
1
3. Use a small flatblade screwdriver to release the duplex-drive assembly hinge (callout 2) on the
power-plug side of the assembly.
TIP: Be careful to not bend the hinge. Straighten the hinge if necessary.
Figure 5-16 Remove the rear cover (2 of 3)
2
106 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...