4. Turn the control panel over and disconnect one FFC (callout 3).
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also,
do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
Figure 5-41 Remove the bezel and control panel (4 of 4)
3
TIP: When you reinstall the control panel, make sure that the tabs at the bottom of the panel
(callout 4) fit underneath the retainers in the scanner body.
4
ENWW Bezel and control panel 121
To Next Page
Loading...