Interlock assembly
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
●
Rear cover. See
Rear cover on page 106.
●
Scanner/ADF assembly. See
Scanner/ADF assembly on page 117.
●
Top cover. See
Top cover on page 108.
2. Remove two screws (callout 1), lift the interlock assembly away from the product, and then
disconnect two connectors (callout 2).
Figure 5-79 Remove the interlock assembly
1
2
152 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...