Main gear assembly and tray 2 pickup solenoid
1. Remove the following components.
●
Right cover. See
Right cover on page 100.
●
Left cover. See
Left cover on page 102.
●
Rear cover. See
Rear cover on page 106.
●
Top cover. See
Top cover on page 108.
●
Convenience-stapler power supply (HP LaserJet M2727nfs only). See
Convenience-stapler
power supply (HP LaserJet M2727nfs only) on page 124.
●
Convenience-stapler power supply bracket and strap (HP LaserJet M2727nfs only). See
Convenience-stapler power supply bracket and strap (HP LaserJet M2727nfs only)
on page 127.
●
Power switch PCA. See
Power-switch PCA on page 130.
●
Fan. See
Fan on page 141.
2. Disconnect one connector (callout 1; J206) at the ECU and pull the wires through the chassis.
Figure 5-91 Remove the main gear assembly (1 of 5)
1
162 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...