ENWW Installing the fax accessory 11
English
10 Connect one phone cord connector (1) into the FAX connector
(2), see Figure 1-10. Push it in until it “clicks.”
Figure 1-10 Making cabling connections - HP LaserJet 4345mfp
11 Connect the other end of the phone cord into the phone jack on
the wall. Push the connector until you hear a click or until the
connector is securely seated. Because there are different types of
connectors, depending on the country/region, the connector
might make an audible click when connected or might not make
an audible click.
12 Plug the MFP AC power cord in and set the power switch to on.
This completes the installation of the fax card. Next, you need to
verify that the fax has been installed correctly and is operating, see,
“Verifying fax operation” on page 20.
LAN Cable (if used)
Phone cord
To Next Page
Loading...
