Control panel message Description Recommended action
have enough memory to load the fonts or
other data.
To solve the problem, increase the amount of
memory for the device. Press
for more
information.
LOAD TRAY X <TYPE> <SIZE>
alternates with
For help press
Tray X is either empty or configured for a type
and size other than that specified in the job.
No other tray is available.
Press for help.
LOAD TRAY X <TYPE> <SIZE>
alternates with
To use another tray press
Tray X is either empty or configured for a type
and size other than that specified in the job.
Press for help.
or
Press
to print from another tray.
LOAD TRAY 1 PLAIN PAPER Sensor PS902 in tray 1 cannot detect paper
in the tray.
1. Verify that paper is loaded in tray 1.
2. Verify that the sensor flag in tray 1 is fully
functional. It should be unhindered and
move freely when paper is loaded.
3. Verify that the sensor connector is firmly
seated in connector J503 on the ECU.
MANUALLY FEED <TYPE> <SIZE>
alternates with
For help press
Tray 1 is empty and no other tray is available. Load media into tray 1, and press to
continue.
or
Press
for help.
MANUALLY FEED <TYPE> <SIZE>
alternates with
To continue press
Media is in tray 1, but the print job requires a
specific type and size that is not currently
available.
Press to print from the tray.
or
Press
for help.
MANUALLY FEED <TYPE> <SIZE>
alternates with
To use another tray press
No media is in tray 1, and a print job requires
a specific type and size that is available in
another tray.
Press to print from another tray.
or
Press
for help.
MANUALLY FEED OUTPUT STACK
alternates with
Then press
to print second sides
The first side of a manual two-sided print job
has been printed and the device is paused
until for the output stack is reinserted.
Take the printed stack out of the output bin
and reinsert it in tray 1 to print the second side
of the two-sided print job. Press
to
continue.
MEM TEST FAILURE REPLACE DIMM 1 The memory DIMM has failed. Install a supported memory DIMM.
NON HP SUPPLY IN USE
alternates with
Ready
The device has detected that a non-
HP supply is currently installed but
was
pressed to override the message.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
NON HP SUPPLY INSTALLED
alternates with
For help press
A new, non-HP supply has been installed.
This message appears until an HP supply is
installed or you press
.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
50 Chapter 2 HP LaserJet P3005 Series printers ENWW
To Next Page
Loading...
