Control panel message Description Recommended action
To continue printing, press .
PAPER PATH JAM FRONT DOOR
alternates with
For help press
A page is jammed in the paper path. Open the front door and remove any jammed
media.
Paused
alternates with
To return to Ready press the STOP key
The device has paused. Press Stop to resume printing.
Performing upgrade A firmware upgrade is in process. No action necessary. Do not turn off the
device.
PRINTING STOPPED
To continue press
This message appears when a Print/Stop test
runs and the time expires.
Press to continue printing.
PROCESSING DUPLEX JOB
alternates with
Do not grab paper until job completes
During duplex printing, the paper emerges for
a short time before it is pulled back into the
device.
Do not pick up pages until they come to rest
in the output bin.
RAM DISK DEVICE FAILURE
alternates with
Ready
To clear press
The RAM disk has failed. Printing can continue for jobs that do not
require the RAM disk.
To remove this message from the display,
press
.
RAM DISK FILE OPERATION FAILED
alternates with
Ready
To clear press
The device received a PJL file system
command that attempted to perform an
illogical operation (for example, to download
a file to a non-existent directory).
Printing can continue.
To remove this message from the display,
press
.
If the message reappears, there might be a
problem with the software program.
RAM DISK FILE SYSTEM IS FULL
alternates with
Ready
To clear press
The device received a PJL file system
command to store something on the file
system, but the file system is full.
1. Use HP Web Jetadmin software to
delete files from the RAM disk memory
and try again.
2. To remove this message from the
display, press
.
RAM DISK IS WRITE PROTECTED
alternates with
Ready
To clear press
The file system is protected and no new files
can be written to it.
1. To enable writing to the RAM disk
memory, use HP Web Jetadmin to turn
off write protection.
2. To remove this message from the
display, press .
Receiving upgrade A firmware upgrade is in progress. Do not turn the device off until the device
returns to Ready.
Replace supply
alternates with
The print cartridge is out and needs to be
replaced.
Install a new cartridge.
ENWW Error codes 51
HP LJ P3005 Series
To Next Page
Loading...
