Control panel message Description Recommended action
For status press
Resend upgrade The firmware upgrade was not successful. Attempt the upgrade again.
RFU LOAD ERROR An error has occurred during a firmware
upgrade.
1. Reinstall the firmware.
2. If the problem persists, contact
HP Support.
SIZE MISMATCH IN TRAY XX
alternates with
Ready
The tray is loaded with a media size that is
different than the size for which the tray is
configured. Printing can continue from other
trays, but not from this one.
1. Make sure the media guides are
adjusted correctly.
2. In the PAPER HANDLING menu,
configure the tray for the correct size.
Sleep mode on The device is in Sleep mode. Any button
press or the receipt of data clears Sleep
mode.
No action necessary. The device
automatically exits Sleep mode.
STANDARD TOP BIN FULL
alternates with
Remove all paper from bin
The output-bin-full sensor (PS4) is signalling
that the bin is full.
1. Empty the output bin. Printing resumes
automatically.
2. If the problem persists, verify that the
connector at sensor PS4 is fully seated.
The other end of the wiring is hard-wired
to the ECU.
Tray X <TYPE> <SIZE>
alternates with
To change size or type press
The device is reporting the current
configuration of tray X.
No action necessary.
Press
to clear the message.
Press
to change the type or size.
TRAY XX EMPTY <TYPE> <SIZE>
alternates with
Ready
The tray is empty, but the current print job
does not require this tray.
Fill the tray. The message indicates the type
and size of media for which the tray is
currently configured.
TRAY XX OPEN
For help press
alternates with
Ready
The tray is open, but printing can continue. Close the tray.
TRAY XX OPEN OR EMPTY
alternates with
Ready
The tray is open or empty, but the current
print job does not require this tray.
Close or fill the tray.
TYPE MISMATCH IN TRAY XX
alternates with
Ready
The tray is loaded with a media type that is
different than the type for which the tray is
configured. Printing can continue from other
trays, but not from this one.
In the PAPER HANDLING menu, configure
the tray for the correct type.
Unauthorized supply in use
alternates with
Ready
The device has detected that a non-
HP supply is currently installed and
(override) was pressed.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs required as a result of using
non-HP supplies are not covered under
HP warranty.
52 Chapter 2 HP LaserJet P3005 Series printers ENWW
To Next Page
Loading...
