Control panel message Description Recommended action
USB ACCESSORY ERROR The device has detected too much current on
the USB storage accessory.
1. Turn the device off.
2. Remove the USB storage accessory.
3. Replace the USB storage accessory.
4. Turn the device on.
USB Storage <X> not functional The USB storage device is not working. Replace the USB storage device.
USB STORAGE DEVICE FAILURE
alternates with
Ready
To clear press
The USB storage device has failed. Printing can continue for jobs that do not
require the storage device.
1. To remove this message from the
display, press
.
2. If the message persists, turn the device
off, remove and re-install the storage
device, and then turn the device on.
3. If the message persists, replace the
storage device.
USB STORAGE FILE OPERATION FAILED
alternates with
Ready
To clear press
The device received a PJL file system
command that attempted to perform an
illogical operation (for example, to download
a file to a nonexistent directory).
Printing can continue.
To remove this message from the display,
press
.
If the message reappears, a problem might
exist in the software program.
USB STORAGE FILE SYSTEM IS FULL
alternates with
Ready
To clear press
The device received a PJL file system
command that attempted to store something
on the file system but was unsuccessful
because the file system is full.
1. Use HP Web Jetadmin software to
delete files from the storage device, and
then try again.
2. To remove this message from the
display, press .
USB STORAGE IS WRITE PROTECTED
alternates with
Ready
To clear press
The file system is protected and no new files
can be written to it.
1. To enable writing to the storage device,
use HP Web Jetadmin to turn off write
protection.
2. To remove this message from the
display, turn the device off and then on.
USB STORAGE X REMOVED The USB storage accessory was removed
while the device was turned on.
1. Turn the device off.
2. To continue using the USB storage
accessory, reinstall it.
3. Turn the device on.
USE TRAY X <TYPE> <SIZE> The device is offering a selection of alternate
media to use for the print job.
1. Use and to highlight a different size
or type, and then press
to select the
size or type.
2.
Press
to return to the previous size
or type.
ENWW Error codes 53
HP LJ P3005 Series
To Next Page
Loading...
