Required tools
●
Number 2 Phillips screwdriver with a magnetic tip and a 152-mm (6-inch) shaft length
●
Precision slotted (flat head) screwdriver with a 1 mm (0.04 in) blade width
NOTE: This fine-point tool is required to release the front door pins. The width of the blade must be
2 mm (0.08 in) or less to be able to drive the door pins out of the mounting holes.
●
Small, slotted (flat head) screwdriver
●
Needle-nose pliers
●
Snap-ring pliers
●
ESD mat (if one is available)
●
Penlight (optional)
CAUTION: Always use a Phillips screwdriver (callout 1). Do not use a pozidrive screwdriver (callout 2) or any
motorized screwdriver. These can damage screws or screw threads.
Figure 1-1 Phillips and pozidrive screwdriver comparison
ENWW Removal and replacement strategy 3
To Next Page
Loading...