Service approach
Before performing service
●
Remove all media from the product.
●
Turn off the power using the power switch.
●
Unplug the power cable and interface cable(s).
●
Place the product on an ESD mat (if one is available). If an ESD workstation or mat is not available,
ground yourself by touching the sheet-metal chassis
before touching an ESD-sensitive part.
●
Remove the toner cartridges.
●
Remove the tray 2 cassette.
After performing service
●
Connect the power cable.
●
Reinstall the toner cartridges.
●
Reinstall the tray 2 cassette.
6 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...