Required tools
●
#2 Phillips screwdriver with a magnetic tip and a 152 mm (6 in) shaft length
●
Precision slotted screwdriver with a 1 mm (0.04 in) blade width
NOTE: This fine-point tool is required to release the front-door pins. The width of the blade must
be 2 mm (0.08 in) or less to be able to push the door pins out of the mounting holes.
●
Small slotted screwdriver
●
Needle-nose pliers
●
ESD mat (if one is available)
●
Penlight (optional)
CAUTION: Always use a Phillips screwdriver (callout 1). Do not use a Pozidriv® screwdriver
(callout 2) or any motorized screwdriver. These can damage screws or screw threads.
Figure 1-1 Phillips and Pozidriv screwdriver comparison
ENWW
Removal and replacement strategy
3
To Next Page
Loading...