HP LASERJET PRO M251nw - Page 78

Fuser
1. Remove the following components:
●
Right cover. See
Right cover on page 15.
●
Left cover. See
Left cover on page 18.
●
Rear right cover. See
Rear right cover on page 21.
●
Rear-upper cover. See
Rear upper cover on page 22.
●
Rear door and rear lower cover. See
Rear door and rear lower cover on page 23.
●
Upper cover. See
Upper cover, LCD control panel products (HP LaserJet Pro 200 color
M251n Printer) on page 26 or Upper cover, touchscreen control panel products (HP LaserJet
Pro 200 color M251nw Printer) on page 28.
2. Disconnect three connectors (callout 1). Release the cables (callout 2) from the cable guide (callout
3).
Figure 1-77 Remove the fuser (1 of 3)
2
3
2
3
1
64 Chapter 1 Removal and replacement ENWW