5. Release two shafts (callout 1) and remove the cartridge door from the top cover.
Figure 1-32 Remove the cartridge door, simplex product (5 of 5)
Top cover, simplex product
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11
●
Input tray assembly. See Input tray assembly on page 11.
●
Output tray assembly. See Output tray assembly on page 11.
●
Left cover. See Left cover, simplex product on page 13.
●
Front cover assembly. See Front cover assembly on page 15.
●
Right cover. See Right cover, simplex product on page 18.
●
Rear cover, simplex product. See Rear cover, simplex product on page 22.
Remove the cartridge door, simplex product
1. Release three tabs (callout 1).
26 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...