5. Release two shafts (callout 1) and remove the top cover from the cartridge door.
Figure 1-37 Remove the cartridge door, simplex product (5 of 5)
Cartridge door, duplex product
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11
●
Input tray assembly. See Input tray assembly on page 11.
●
Output tray assembly. See Output tray assembly on page 11.
●
Left cover. See Left cover, duplex product on page 12.
●
Front cover assembly. See Front cover assembly on page 15.
●
Right cover. See Right cover, duplex product on page 16.
●
Top cover cap, duplex product. See Top cover cap, duplex product on page 14.
Remove the cartridge door, duplex product
1. Release three tabs (callout 1).
ENWW Removal and replacement procedures 29
To Next Page
Loading...