2. Release four tabs (callout 1) and remove the left cover (callout 2).
Figure 1-49 Remove the left cover (1 of 1)
Front cover assembly
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 36
●
Input tray assembly. See Input tray assembly on page 36.
●
Output tray assembly. See Output tray assembly on page 37.
●
Left cover. See Left cover on page 37.
Remove the front cover assembly
1. Disconnect one FFC (callout 1) from the formatter.
38 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...