3. Release three tabs (callout 1), and then remove the front cover (callout 2).
Figure 1-52 Remove the front cover (3 of 3)
Right cover
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 36
●
Input tray assembly. See Input tray assembly on page 36.
●
Output tray assembly. See Output tray assembly on page 37.
●
Left cover. See Left cover on page 37.
●
Front cover assembly. See Front cover assembly on page 38.
Remove the right cover assembly
1. Remove one screw (callout 1).
40 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...