2. Remove four screws (callout 1), and then remove the duplex frame (callout 2).
Figure 1-64 Remove the duplex frame (2 of 2)
Cartridge door
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 36
●
Input tray assembly. See Input tray assembly on page 36.
●
Output tray assembly. See Output tray assembly on page 37.
●
Left cover. See Left cover on page 37.
●
Front cover assembly. See Front cover assembly on page 38.
●
Right cover. See Right cover on page 40.
●
Top cover. See Top cover cap on page 50.
Remove the cartridge door
1. Release four tabs (callout 1).
48 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...