HP LaserJet Pro MFP M225 - Page 70

3. Remove the cartridge door (callout 1).
Figure 1-67 Remove the cartridge door (3 of 3)
1
Top cover cap
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 36
●
Input tray assembly. See Input tray assembly on page 36.
●
Output tray assembly. See Output tray assembly on page 37.
●
Left cover. See Left cover on page 37.
●
Front cover assembly. See Front cover assembly on page 38.
●
Right cover. See Right cover on page 40.
●
Cartridge door. See Cartridge door on page 48.
Remove the top cover cap
▲
Remove four screws (callout 1) and the top cover (callout 2).
50 Chapter 1 Removal and replacement ENWW