Fuser
Before proceeding, remove the following components:
●
Dust cover. See Dust cover on page 11 or Dust cover on page 36
●
Input tray assembly. See Input tray assembly on page 11 or Input tray assembly on page 36.
●
Output tray assembly. See Output tray assembly on page 11 or Output tray assembly on page 37.
●
Left cover. See Left cover, duplex product on page 12 or Left cover, simplex product on page 13 or Left
cover on page 37.
●
Front cover assembly. See Front cover assembly on page 15 or Front cover assembly on page 38.
●
Right cover. See Right cover, duplex product on page 16 or Right cover, simplex product on page 18 or
Right cover on page 40.
●
Rear cover (simplex product) or duplex door (duplex product). See Rear cover, simplex product
on page 22 or Duplex door, duplex product on page 20 or Duplex door on page 46.
●
Duplex frame (duplex products only). See Duplex frame, duplex product on page 21 or Duplex frame
on page 47.
●
Cartridge door. See Cartridge door, duplex product on page 29 or Cartridge door, simplex product
on page 23 or Cartridge door on page 48.
●
Top cover. See Top cover on page 33 or Top cover on page 52.
●
Formatter PCA. See Formatter PCA on page 54
Remove the fuser
1. Duplex models only: Release two tabs (callout 1), and then remove the duplex reverse guide (callout 2).
Figure 1-74 Remove the fuser (1 of 10)
To Next Page
Loading...