20 – Control panel messages
EN
5Si Mopier
x=output device number
yy=condition code
For the multibin mailbox:
01 = face-up tray not installed
Note
See also the section on troubleshooting the 2,000-sheet input unit
and multibin mailbox/mailbox with stapler.
LJ 5
• See 13 Paper Jam—all printers
• The rear door is open.
• The cassette paper out sensor flag is broken or missing.
• The 500-sheet lower cassette is not properly adjusted (see service
note C2001A-04).
– Adjust the tray, using the instructions in the service note.
• Check the transfer roller to ensure that it is properly seated.
• The input sensor (PS1) or fuser exit sensor (PS3) is bad; or with
jams from the MP tray (Tray 1), the paper end sensor (PS5) is bad.
5Si Mopier
• Send print jobs of only 20 pages or fewer to the stapler.
Output Operation Condition x.yy
Remove Paper Jam
Staple Limit Reached
To Next Page
Loading...
Need help?
General
