28 – Control panel messages
EN
IIID, III, IID, II
• The registration assembly is defective.
• The fuser is defective.
IIID, IID
• The duplex paper path is obstructed or contains worn components.
• The switchback assembly is misadjusted or bent.
III, II
• The sensor cable is defective.
– Replace the fuser to the DC controller cable (RG1-0907-000CN).
2686D/A
• The separation belt is broken.
• The transfer guide assembly is defective.
• The paper pickup clutch is turning more than once.
– Disassemble the clutch and re-grease. NOTE: If one clutch
needs re-greasing, it is likely that they all do.
• The registration shutter is stuck.
• The rear paper guide door is worn.
– Replace the worn paper rollers or readjust the rear door.
• The front paper guide door is worn or misadjusted, preventing paper
from getting to the registration assembly on time.
– Readjust the front paper guide door.
To Next Page
Loading...
Need help?
General
