HP Latex 300 Series - Page 20

LFP Customer Assurance
20
HP
Set up your tiles for Fotoba XLD170WP cutting (Caldera RIP software)
Open the Tiling function and drag a picture into it (in this case the size is 4000 x 3000 mm).
Enable
extend image to poster size
and lock the image dimensions (red circles below).
Increase both dimensions by 4 mm (this will create a 2 mm bleed on the outer side for each side) and disable
the “
Proportion
” option.
Select the number of columns. For this example, we set four columns.
+ 4 mm, both width
and height