HP Latex 300 Series

To Next Page

To Previous Page

LFP Customer Assurance

Select the

tab and make sure that

X/Y

is enabled (Nest-O-Ba key is required) as well as the four cut

marks. Move then to the

X/Y

tab and adjust the setting as follows:

NOTE

: the value for

Number

(green circle above) depends on how many vertical

knives you can install in the

Fotoba XLD 170 WP cutter.

Please check and set the Double mark and Single mark as follows:

Press

Apply

in order to confirm the selections.

HP Latex 300 Series - Page 19