Power supply
1. Remove the following assemblies:
●
Right and left covers. See
Side covers on page 104.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 107.
●
Front cover. See
Front cover on page 109.
●
Speaker assembly. See
Speaker assembly on page 111.
●
Formatter and fax card. See
Formatter and fax card on page 113.
2. Disconnect one spade connector (callout 1) and remove three screws (callout 2).
Figure 5-69 Remove the power supply (1 of 7)
1
2
114 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...