HP M401

Wireless Configuration (wireless models only)
Use the Wireless Configuration page to turn off/on the wireless capabilities for the product.
Figure 2-37 HP Device Toolbox, Networking tab – Wireless Configuration page
Wireless Direct Setup (wireless models only)
Use the Wireless Direct Setup page to enable devices within wireless range to connect to the
product and print.
Figure 2-38 HP Device Toolbox, Networking tab — Wireless Direct Setup page
Network Identification
Use the Network Identification pane to configure the host name and domain name(s) used to
identify the product on the network.
The values for host name and domain names are retrieved from the firmware, and displayed on this
pane. The networking firmware determines what host name and domain name(s) to use.
The information under Available Host name / Domain names is for information only and cannot
be modified.
The text entries are disabled under certain circumstances. The following table defines when the entities
are disabled:
70 Chapter 2 Windows software description and installation ENWW