Front-door opening/closing switch (PS14)
NOTE: This switch is also activated by the right door. See Right-door opening/closing sensor (PS15)
on page 282. During this test, the right door must remain closed.
1. Open the front-door assembly to disengage the front-door opening/closing switch.
2. Close the front-door assembly, and then check the control panel on the product for sensor response.
TIP: You can leave the front door open and use a folded piece of paper to activate the switch.
Figure 3-4 Test the front-door opening/closing switch
3. Check the control-panel display for sensor response.
4. If there is no response, replace the front-door opening/closing microswitch or the cable.
ENWW Tools for troubleshooting 281
To Next Page
Loading...