USB storage device (Preboot menu)
1. Copy the xxxxxxx.bdl file to a portable USB flash memory storage device (thumb drive).
2. Turn the product on.
3. Press the Stop button when the Ready, Data and Attention LEDs illuminate solid.
4. Press the down arrow
button to highlight Administrator, and then press the OK button.
5. Press the down arrow
button to highlight Download, and then press the OK button.
6. Insert the portable USB storage device with the xxxxxxx.bdl file on it.
NOTE: If the error message No USB Thumbdrive Files Found appears on the control-panel display,
you might need to connect the storage device to the external USB connection on the formatter or try
using a different portable storage device.
7. Press the down arrow button to highlight USB Thumbdrive, and then press the OK button.
8. Press the down arrow
button to highlight the xxxxxxx.bdl file, and then press the OK button.
NOTE: The upgrade process can take up to 10 minutes to complete.
TIP: If there is more than one xxxxxxx.bdl file on the storage device, make sure that you select
the correct file for this product.
9. When the message Complete appears on the control-panel display, press the Back button 3 times.
10. When the message Continue appears on the control-panel display, press the OK button. The product will
initialize.
11. When the upgrade process is complete, print a configuration page and verify that the upgrade firmware
version was installed. See
Configuration page on page 339 and Determine the installed revision of
firmware on page 535.
536 Chapter 3 Solve problems ENWW
To Next Page
Loading...